Monday, September 01, 2014

Bernie's Birthday Bowl

This series of photos shows the process of turning a large box elder bowl I gave to my wife as a birthday present.  The photos are largely self-explanatory, but I'll add a few comments.

The blank is held between centers and the bark largely removed; the flats from sawing are still present:



The bark is now gone; you can see the three-point drive center I'm using on the headstock end. Since the side-mounted points are adjustable it's very handy for holding an uneven surface securely:


The blank is now nearly round. At this point I cut a recess (shown later in the series) in the base for expansion jaws to hold the blank for hollowing:



I've reversed the bowl blank so that it is now held in the chuck for hollowing, but before that I'll true up the rim and even up the top surface some - and then get rid of the tailstock support:


The following photo is of the same set up, but shows the chuck expanded to hold the blank in the recess:



Beginning to hollow out the inside:



Same stage, showing my lathe:


Lots of shavings, of course... 


Selfie! 


The bowl rough-hollowed, showing the heavy curly shavings from the hollowing process:


After rough turning the bowl I put it in a paper bag for a couple of weeks to dry some:


This photo shows the recess cut in the base for the expansion jaws:


The inside of the bowl is nearly fully turned:


And the outside is completed:


Ready to power sand and then remove for finish sanding and finishing: 


The final product. Finished with three coats of Danish oil and three coats of wipe-on poly:







1 comment:

Tommy said...

Hey doug, nice work on that bowl for your wife! Saw your link on FB You can visit my site here http://www.BostonWoodturning.com Haven't added all my good piece yet because I'm still working on my website. Feel free to visit!.